But I am not a programmer so I have to leave it to ya'll to figure out the programming end HI. I have used CHIRP with my Yaesu VX-5R and BaoFeng UV-5R and they both work good with my setup. There has to be something wrong in the CHIRP TS-2000 module. I also use Ham Radio Deluxe and DXBase on a daily basic and they both connect and work perfect all the time. I also tried the pickest programs that I know of as far as timing, serial ports etc (the Kenwood MCP-2000 and ARCP-2000 programs) and both works first time every time on the same serial port, speed, etc. Ok, Just tried 9600 baud and still no go. Since the probe tries 9600 first, I figure trying with that for starters might get us somewhere. Tom, he's getting something from the radio during the initial rate probing, and it looks like maybe it's getting hung up after that fails a first time. Can you set the radio's data rate to 9600? Please do that, close out of CHIRP completely, reset the radio, reboot your computer (just to be sure), and then try again.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |